|Inside Out of the Samsung Infuse 4G - Atom8 - Feb 03, 2012 4:31am|
|Tips & Tricks @ Technology / Mobile Phones / Samsung / Infuse (SGH-I997) - Views (5326) - ( Unrated )|
|Here are the steps to open up the Infuse 4G. Had to do it after dropping it in the tub (yes, it was saved). Took the pix along the way to show y'all.
Start with a dead fone:
Flip it over and remove rear cover, SIM, battery, memory card and all screws:
Use a pry tool or some good finger nails(no freaky nails needed, just decent trimmed nails :-]) and pry along the edge of the screen (easiest is to start at mid-left to bottom of the fone). Remember to press a bit from the rear battery compartment while prying along the edge to pop out the screen easier as below:
Removed rear shell and screen assembly:
Remove rear camera unit, it is stuck to the main board with double-sided adhesive, just pry it slowly below the square PCB and it'll come up. Then remove it out of the socket and disconnect the short and wide ribbon connector to the main board.
**You may not have to remove the camera if you can manage to pry it out of the square socket. It'll go along with the main board just fine. Though I had to remove for water dry-off measures.
To remove the mainboard out:
a - Disconnect the front camera connector (top right of fone looking from rear)
b - Disconnect the screen connector next to the SIM slot, just pop it up
c - Disconnect accessory connector, right below the ear-plug assembly
d - Disconnect the navigation keys connector at bottom right of the board
e - Remove the 2 screws on the board. One at top between the camera and the ear plug. One at near bottom right a little bit above the bottom right connector.
Now gently lift up the main board off the screen assembly and avoid breaking the connectors flexing in the way:
To better dry off water, I had to remove the front camera and ear-plug, vibrate motor and sensors assemblies:
Now just use the hair dryer at low settings and give it a good 5-10min heat and air. Then, put all the bits back together... Poof! It's alive!
Last Edit: Feb 03, 2012 4:43am - by Atom8 |
( Guest User ) - May 10, 2013 5:29pm - Rating: None
dfg dfgdfg dfg dsfg dfg d
Tips & Tricks
|Saab 92x Ecopower engine ignition coils|
:: TwinsAuto - Jul 16, 2008 5:34pm
MacOSX 'smbclient' command connects to WinXP PC
:: Atom8 - Dec 15, 2007 10:26pm
iPhone 3G with 4.2.1 iOS and 05.15.04 baseband jailbreak & unloc...
:: Atom8 - Jul 10, 2011 3:22pm
Free Serial port - RS232 Data Logger
:: Atom8 - Apr 21, 2008 3:14pm
Methods to Set the Samsung Galaxy S 4G to Download Mode
:: Atom8 - Jun 24, 2011 6:43pm
Unicode Viet Type Conversion for CGI using Perl
:: BanThad - Jun 04, 2007 7:50am
Update FW to 2.3.4 Gingerbread for T-Mobile Vibrant (Samsung Gal...
:: Atom8 - Jul 10, 2011 3:41pm
Timing chain tensioner removal on Benz 560SL 1986
:: TwinsAuto - Jan 19, 2008 4:52pm
SELECT query input must be integer
:: Atom8 - Jan 08, 2008 2:20pm
Inside Out of the Samsung Infuse 4G
:: Atom8 - Feb 03, 2012 4:31am